Unitech MS920 Manuel d'utilisateur télécharger pdf (Page 90)

- 84 -

Turn off after good read

- When active, the scan engine stops the reading session after a successful

decoding.

- Turn off after good read is only used in the following trigger modes:

- Level

- Pulse

- Autostand

- Standard Aim

NOTE: this parameter is NOT used with conti

Enable (*)

Disable

Retrigger delay

- Only valid if "Turn off after good read" is disabled.

- This setting is a time delay in which the scanner turns off after a good read.

When the delay is done, the scanner automatically turns back on (retriggers).

- Value is in milliseconds.

0 (*)

Compose: Please refer to SCM (Software Conguration Manager) in CD

Aimer mode

- Allows you to locate the bar code you want to read.

- The aiming beam is only used with the following trigger modes:

- Level

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 117 118

Pas de commentaire

Unitech MS920 Manuel d'utilisateur Page 90