Unitech HT580 Spécifications télécharger pdf (Page 12)

HT580 User Reference Guide Unitech Electronic CO. LTD

2.1.2- 2 < SCANNER >

Press [2] or [scan] to enter <SCANNER> mode. Press [ESC] to return to the device setting mode.

< SCANNER > selection: ON NORMAL/ON FLASH/OFF. Selecting your preference and press [ENTER]

to complete the setting.

2.1.2- 3 < AUTORUN>

Press [3] or [scan] to enter <AUTORUN> mode. Press [ESC] to go return to the device setting mode.

<AUTORUN> automatically runs the selected program once you change the default. AUTORUN default

is set up on <OFF> mode. Three programs can be selected: < FORMCACHING>, <APG580>, and <OFF>.

Once you dene the selected program, the program will automatically activate when you restart the unit.

The main menu will run in the program.

2.1.3 < MODEM INIT >

To perform modem command, plug in the modem and it will be automatically initiated. To execute <MODEM

INIT>, press [3] or [scan] to enter this mode. Press [ESC] to go back to the previous menu.

2.1.4 < SUPERVISOR >

When entering into <SUPERVISOR> mode, you will be required to input your password.

For password and detail reference, please refer to the Technical Binder.

Press [4] or [scan] to enter <SUPERVISOR> mode setting. Press [ESC] to go back to the previous menu.

2.2 FORMCACHING

In the main menu, there is FORMCACHING to be performed while scanning.

In the default setting for FORMCACHING, you will see “Item” as dened in eld 1 and “Qty” as dened in

eld 2. To change the default of the eld, go to “FORM” under “SUPERVISOR” in the mode category. To

start <FORMCACHING>, press [2] or [scan] to enter and press [ESC] to go back to the previous menu.

2.3 RUN APG580

To run on “APG580”, please refer to the technical binder for detailed instructions.

1 2 ... 7 8 9 10 11 12

Pas de commentaire

Unitech HT580 Spécifications Page 12