Unitech HT680 Manuel d'utilisateur télécharger pdf (Page 50)

2. Under Main tab, select the profile you want

to activate.

3. A pop-up window appears “A Power Cycle is required to make settings

activate properly.” Tap OK, and then tap OK to exit the Summit Client

Utility.

4. Tap Start → Programs → Utilities → Boot-Mode. Tap Warm Boot

to warm start the terminal and load the previous settings.

5. The Summit icon on the taskbar indicating

the AP is connected.

Double tap this icon to bring up Summit

Control Utility. Tap Disable Radio, you can

disconnect the AP.

Under Status tab, you can see the IP

address, signal strength and quality.

If you want to learn more detailed settings of the SUMMIT utility, please visite

SUMMIT website (http://www.summitdatacom.com/documentation.htm)

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 74 75

Pas de commentaire

Unitech HT680 Manuel d'utilisateur Page 50