Unitech MS350 Manuel d'utilisateur télécharger pdf (Page 12)

Auto Update

When this feature is enabled, an imager and its linked cradle

can automatically ensure they stay in sync with regard to

firmware and/or configuration. This is accomplished by the

linked imager and cradle comparing firmware version number

and configuration file check sum. If either is different, the

cradle will automatically update the imager with its

firmware/configuration.

If the units are linked, any changes made to the cradle’s

configuration through the scan utility software will

automatically be sent to the imager at the completion of the

programming session. By the same token, any changes

made to the linked imager’s configuration will be transmitted

to the cradle at the end of the programming session.

The following options are available for Auto Update:

? Enable configuration and firmware auto update –

Allows both configuration and firmware updating

(Default).

? Enable configuration auto update only – Allows

only configuration updating.

*$%-1BA00%%*

*$%-1BA01%%*

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 132 133

Pas de commentaire

Unitech MS350 Manuel d'utilisateur Page 12