Unitech MS210 Manuel d'utilisateur télécharger pdf (Page 5)

Page 4

Chapter 2 Keyboard Interface

As a keyboard Interface, the scanner is actually installed between PC

(or terminal) and keyboard. See Figure 1 for reference. The scanner

sends data to the host device by emulating the keyboard signals input

and acts like an extension of the keyboard.

2.1 Installation

This scanner can be installed easily by following the installation guide

illustrated below. Before you start the installation, locate a “Y” type

cable in the package.

Installation procedures:

1) Plug the modular (RJ45) connector of the “Y” cable into the bottom

of the scanner until you hear a click sound.

PC or Terminal

Keyboard

Figure 1. Installed as a Keyboard Interface

Interface Cable ("Y" Cable)

Modular Connector

SCANNER

2) Turn off your PC or terminal.

3) Unplug the keyboard from the PC or terminal.

4) Plug the keyboard into a connector of the Y cable that mates with it.

5) Plug the remaining connector of the “Y” cable into the keyboard

port of your PC or terminal.

6) Power up your PC or terminal you press the switch the beam should

be out from the scanner.

1 2 3 4 5 6 7 8 9 10 ... 54 55

Pas de commentaire

Unitech MS210 Manuel d'utilisateur Page 5